SSQ
SSQ XLRJS3
SSQ XLRJS3
Warsaw Showroom
Nowogrodzka 6
102
00-513 Warszawa
Poland
Choose options
SSQ XLRJS3 is a three-metre balanced cable with a 3-pin female XLR socket on one end and a 6.3 mm stereo jack on the other. That pairing covers every point where the source hands over a signal on XLR while the destination only takes a TRS jack.
One cable instead of a stack of adapters
The scenario repeats in every studio and on every stage: a preamp, mixer or stagebox sends the signal out on XLR, while the input on the interface, processor or active monitor is a large jack. The usual fix is an adapter screwed onto a plain mic cable, which means one more contact point that starts crackling after a season and falls out the moment somebody brushes past it. XLRJS3 covers the run with a single lead, keeps the balanced pair intact end to end and seats the connector in the socket the way it was meant to sit.
A lead that survives the tour
The conductors use 6N grade OFC copper in a 30 x 0.1 stranded build, so daily coiling and uncoiling does not fatigue them. A cross-braided copper shield with at least 90 percent coverage keeps power bricks, dimmers and everything else living under the stage out of the signal. Connectors are soldered with lead-free silver-bearing tin and protected against cable pull-out, and a hook-and-loop tie ships with every unit, so the cable goes back into the case coiled rather than knotted. The manufacturer covers it with a lifetime warranty.
KEY FEATURES
- Connectors: 3-pin female XLR and 6.3 mm stereo jack
- Balanced signal path maintained over the full length
- 6N grade OFC copper, made in Poland
- Cross-braided copper shield with at least 90 percent coverage
- Connectors soldered with lead-free silver-bearing tin
- Strain relief protecting the connectors against cable pull-out
- Hook-and-loop cable tie included with every unit
- Lifetime manufacturer warranty
TECHNICAL SPECIFICATIONS
- Length: 3 metres
- Conductor: 2 x 0.23 mm², 30 x 0.1 stranded multi-wire copper
- Outer cable diameter: 6 mm
- Impedance: 85 Ω ±5
- Capacitance at 1 kHz: up to 65 nF/km conductor to conductor, up to 130 nF/km conductor to shield
- Minimum insulation resistance: 1.0 GΩ x km
- Minimum bend radius: 5 x cable diameter
- Operating temperature: -30 to 70 °C fixed installation, -5 to 70 °C mobile use
- Manufacturer code: SS-2061
