Samar Audio Design VL37A is the active version of the VL37 ribbon: the same MF65-derived ribbon motor, but with electronics that lift the output to a condenser-like level and cut noise by 4-5 dB compared to the passive VL37. Figure-8 pattern, 20 Hz - 25 kHz, handcrafted in the USA.
A ribbon that does not crave gain
A passive ribbon needs an expensive, quiet high-gain preamp and a cable that does not load it down. The VL37A offers 8.4 mV/Pa sensitivity and a 65 ohm output impedance, so it works happily with the preamps in an ordinary interface, and cable length stops affecting the tone. That matters on quiet sources: strings, piano, voice, location recording.
The ribbon motor and tuning are the same as in the passive VL37 and in the MF65, so only the electronics change. In practice that lowers the demands on the chain: you need neither an exceptionally quiet preamp nor expensive cable. The microphone has a stainless steel body, a wooden box and a shock-proof clip, and Samar gives 15 days to check that the sound suits you.
Quiet where ribbons used to struggle
Samar designed the VL37A for classical, film, broadcast and studio work. The symmetrical figure 8 with a pop filter also handles overheads, cabinets and room miking. Phantom power is required.
KEY FEATURES
- Active ribbon microphone, figure-8 pattern
- 4-5 dB lower noise than the passive VL37
- Condenser-like output level
- Low output impedance, less sensitive to cable and preamp choice
- In-house toroidal transformers, ribbon with proprietary corrugation
- Stainless steel body, wooden box and shock-proof clip included
- Made in the USA, 5-year parts and 2-year ribbon replacement warranty
TECHNICAL SPECIFICATIONS
- Pickup pattern: figure 8
- Frequency response: 20 Hz - 25 kHz
- Ribbon: 50.8 x 6.35 mm, 1.5 microns
- Sensitivity: 8.4 mV/Pa
- Output impedance: 65 ohms
- Dimensions: 163 x 33 mm (6.42 x 1.3 in)
- Weight: 230 g (8.2 oz)





