AsciLab BX8C Pair is a pair of active bass modules with a cardioid pattern, built by AsciLab for the C8C monitors. Each module carries four 8-inch aluminium woofers and two 250 W amplifier channels in a two-way DSP layout, and the cabinet is meant to stand under a C8C.
Low end that does not flood the room
A normal subwoofer excites the room, and wall reflections return as long tails of bass. The BX8C is cardioid, so most of its energy goes forward and much less radiates toward the rear wall. Together with the C8C the system reaches down to 20 Hz without smearing the lowest octaves, which a distributor describes as full-range 20 Hz - 20 kHz operation.
The cabinet is 350 mm deep and 254 mm wide, identical to the C8C. The modules are meant to work with the C8C monitors and come in colours matched to them. Two 250 W amplifier channels drive four woofers, which gives large dynamic headroom in the lowest octaves.
Sized to sit under the C8C
The module measures 800 x 254 x 350 mm, the same cross-section as the C8C, so the two cabinets stack into a single tower. The BX8C connects to the C8C in a daisy chain, and the DSP is built into the module. Without the C8C the module is not a full monitor, it is the bass extension of this system.
The whole thing works as a system with the C8C: the monitors stand on the modules, and both layers share a cardioid radiation pattern in the lower range. It is a solution for studios where, because of the wall behind the monitors, a classic setup with a subwoofer does not give an even bass.
KEY FEATURES
- Active two-way bass module with DSP, cardioid directivity
- Four long-throw 8-inch aluminium woofers
- Two amplifier channels of 250 W each
- Same cross-section as the C8C, stacks into a tower
- Daisy-chain connection to the C8C
- Supplied as a pair
TECHNICAL SPECIFICATIONS
- Type: active two-way bass module, cardioid
- Drivers: 4 x 8 in aluminium woofer
- Amplification: 2 x 250 W (Hypex)
- Dimensions: 800 x 254 x 350 mm
- Supplied as: 2 modules
- Works with: AsciLab C8C



