Active PA Speakers: How Many Do You Need, and Which Ones?
In a typical bar, club or hall, two active PA speakers do the job, and a subwoofer joins them once the music grows a kick drum. You need more than that only when the room is long, the crowd is spread thin, or the venue is big enough that one pair would have to shout to reach the back wall. That is the short answer. The useful one is that the number comes from three things you can check with a tape measure and a playlist: how the speaker spreads its sound, how far it has to throw it, and what kind of sound it carries. (If the other boxes in the chain are still a blur, our guide to what a PA system is comes first.)
The short version. Start with a pair of active speakers. Add a subwoofer when the programme has real low end, and add more boxes only when one pair cannot cover the depth of the room. Read the coverage angle before the watts. For a band that plays small and medium rooms, the Solton aart T-12 A is where I would start looking.
Jump to:
A pair first, then the room decides
A pair does two jobs. It covers the room from both sides, so nobody is parked in a dead spot while the other half of the room gets the full blast, and it splits the work between two cabinets. You can run a single speaker for a talk or a solo singer, and plenty of venues do. The moment the room has width, the second box earns its place.
A subwoofer is a separate decision. Tops are built to carry voices and instruments. Hand them a kick drum and a bassline and they spend their amplifier on the lowest notes instead of the clarity you paid for. A sub takes the bottom octaves off their hands, which is why the same pair sounds cleaner at the same volume with a sub underneath it. Nice thing to find out, awkward thing to explain to whoever sold you bigger tops.
Anything beyond a pair is a coverage problem, not a loudness problem. A long hall or a church with a deep nave sometimes wants a second pair further back, set up as delay speakers. That is installation territory, and my advice there is short: have someone measure it.
Three things that set the number
1. Coverage. Every datasheet lists two angles, horizontal by vertical. The aart T-10 A, the aart T-12 A and the IP 8 give 90° × 60°: wide, and fairly tall, which suits an ordinary room. The CT 5 N column in the TWA 15 Array gives 120° × 20°, very wide and very flat. The Karat K 4 A, a line-array element, gives 100° × 10°. Narrow vertical coverage keeps sound off the ceiling and the floor, which is the whole point in a church with a high, hard ceiling that turns every stray reflection into mush.
2. Throw. In open space the level drops by about 6 dB every time the distance doubles. The maximum SPL on a datasheet is normally measured close to the cabinet (check the distance in the sheet), so the listener at the back gets less than the number on the box. Indoors, reflections give some of it back, which is why the same speaker sounds louder in a small hall than on a lawn. It is also why a speaker on a stand at head height or above reaches the back of the room, while the same speaker on the floor addresses the first three rows at knee level.
3. Content. Speech needs clarity and very little bass, so a column or a small top is plenty. A DJ set or a band pushes sub-bass and fast, loud transients, which is where a subwoofer and a bigger top earn their space in the van.
Active or passive, in one paragraph
Active speakers have the amplifier inside, matched to the drivers by the manufacturer. Passive speakers need an amplifier that you choose and carry. Neither is better by category: active is more predictable out of the box, passive is lighter and easier to install. In this guide the aart T models are active and the IP 5 CX and IP 8 are passive, so they need a power amplifier behind them. The TWA 15 and SIERA systems come as a top plus an active subwoofer. We go through the same fork for the studio in our guide to choosing active studio monitors.
Room by room
A bar, café or restaurant with background music. You want even, polite sound and speakers that do not take over the room. The IP 5 CX is a 5-inch coaxial speaker at 2.5 kg with 100° coverage, and the IP 8 is the 8-inch step up at 200 W and 8.5 kg. Both are passive and meant for fixed installation and light mobile use, so budget for an amplifier. The manufacturer names bars and restaurants as their home turf.
A singer and a guitar, no mixer. The aart T-10 A is an active two-way 10-inch with two combo inputs, one of them with a microphone preamp, and four DSP presets. It is rated at 300 W and 123 dB continuous. Plug in a dynamic microphone and a guitar and you have a small gig in one 14.8 kg box. Not sure which microphone? Our guide to condenser versus dynamic settles it for the stage.
The one opinion in this article: in a small room, buy the smaller box and put it higher. Between the T-10 A and the T-12 A the datasheet gap is 2 dB (123 against 125 dB continuous) and 1.2 kg (14.8 against 16 kg). Two decibels is a step you hear when you switch back and forth, not one that changes how the night goes. Getting the speaker up to head height usually does more for the back rows than two extra decibels, and it costs a stand. Nobody ever left a bar saying the PA was two decibels short of eleven.
A band that plays loud. This is where the aart T-12 A belongs: 500 W, 125 dB continuous, two-way 12-inch, 16 kg. A pair of them fits most pubs and small halls. Count your inputs before your watts, though. Five musicians need more channels than two combo inputs on the back of a speaker, and that is the job of a mixer. What a mixing desk actually does is a guide of its own: what does a mixing desk do.
A DJ set or a party. Bass is the one thing at a party that everyone feels and nobody thanks. The TWA 15 Classic puts a 15-inch active subwoofer (35 to 200 Hz, with Bluetooth) under a passive HD 101 top, and the sub also powers the top, so there is no separate amplifier to find. The top is rated at 300 W and 123 dB, the sub at 500 W and 127 dB. Weight is 13 kg for the top and 31 kg for the sub, so plan the stairs.
A church, theatre or conference room. Here you want clear speech and a speaker that stays out of the way. The TWA 15 Array pairs the slim CT 5 N column (150 mm wide, 8 kg, 120° × 20°, four 5-inch drivers) with the same 15-inch active sub. The narrow vertical angle is the feature: it aims sound at the audience instead of the ceiling. The manufacturer lists theatres and churches for the CT 5 N.
Medium festivals, clubs and theatres. The Karat K 4 A is an active line-array element, four 5-inch drivers, 600 W, 100° × 10°, 17 kg. The datasheet gives no maximum SPL, so I will not invent one. The manufacturer recommends its SUB K 15 A for the bass. For a bigger step up, the SIERA system pairs a top (500 W, 137 dB) with an active dual 15-inch sub (1000 W, 134 dB). It weighs 19 kg for the top and 46.5 kg for the sub, which makes it the one in this guide you do not carry alone.
Eight models, datasheet numbers
All figures come from the manufacturer's datasheets. Prices are today's shelf prices in euro.
| Model | Type | Power | Max SPL | Coverage | Weight | Price |
|---|---|---|---|---|---|---|
| IP 5 CX | passive, 5" coaxial | 80 W | 117 dB (peak) | 100° | 2.5 kg | 204 |
| IP 8 | passive, 2-way, 8" | 200 W | 118 dB | 90° × 60° | 8.5 kg | 227 |
| aart T-10 A | active, 2-way, 10" | 300 W | 123 dB | 90° × 60° | 14.8 kg | 613 |
| aart T-12 A | active, 2-way, 12" | 500 W | 125 dB | 90° × 60° | 16 kg | 794 |
| TWA 15 Classic | HD 101 top + active 15" sub | top 300 W, sub 500 W | top 123 dB, sub 127 dB | top 90° × 60° | 13 kg + 31 kg | 1,271 |
| TWA 15 Array | CT 5 N column + active 15" sub | top 320 W, sub 500 W | top 122 dB, sub 127 dB | top 120° × 20° | 8 kg + 31 kg | 1,362 |
| Karat K 4 A | active line-array element, 4 × 5" | 600 W | not in datasheet | 100° × 10° | 17 kg | 1,135 |
| SIERA | top + active dual 15" sub | top 500 W, sub 1000 W | top 137 dB, sub 134 dB | top 120° × 20° | 19 kg + 46.5 kg | 2,244 |
One trap in the table: the manufacturer quotes maximum SPL as a peak value for the IP 5 CX and as a continuous value for the aart T and HD models, so do not compare rows without checking which is which. Power on passive speakers is what they can handle, on active ones it is the amplifier inside.
When this is the wrong gear
Solton is stage and installation equipment. If you want speakers for mixing music at home, that is a different job and a different shelf: have a look at studio monitors. If the project is a school with a ceiling speaker in every classroom, you want an installation contractor rather than a music shop, and we explain why in the PA system guide. Saying so costs us a sale and saves you a return.
Come to Nowogrodzka 6A/102 with the dimensions of the room and the kind of nights you play, and we will work out the number of boxes with you. Every product carries a 36-month warranty, returns are open for 30 days, and we ship to every EU country.
Straight answers
How many PA speakers do I need?
For most small and medium rooms, a pair of active speakers, plus a subwoofer if the music has strong low end such as a DJ set or a band with a kick drum. More boxes only make sense when one pair cannot cover the depth or width of the room. Check the coverage angle on the datasheet and the distance to the back row before adding anything.
Do PA speakers need power?
Every speaker needs power from somewhere. Active speakers have the amplifier built in, so you plug the cabinet into the mains and feed it a signal. Passive speakers have no amplifier, so you need a separate power amplifier of a suitable rating connected to them.
What are self-powered speakers?
Self-powered is another name for active: the amplifier sits inside the cabinet and the manufacturer has matched it to the drivers. You carry one box per side instead of speakers plus a separate amplifier.
Do I need a subwoofer for a PA?
It depends on the programme. Speech and quiet background music rarely need one. A DJ set, a band with a kick drum or bass guitar, or any room where the low end should be felt usually benefits from a sub, because it takes the lowest octaves off the tops and leaves them to handle the rest more cleanly.
Are active PA speakers better than passive ones?
Not by category. Active speakers are more predictable, because the amplifier is matched to the drivers by the manufacturer, and they are fewer boxes to carry. Passive speakers are lighter and easier to install permanently, and a well-matched passive rig can sound excellent. The difference is in how predictable the result is, not how good it can ultimately be.
Get the number of boxes right and the loudest complaint left is about the setlist. Get it wrong and the first thing the singer hears is feedback, the only encore nobody asked for.
Read next
- XLR vs USB Microphone. Only one of the two plugs into a PA, and it matters the day you play live.
- What Is a Preamp?. The gain stage behind the microphone input on the back of that speaker.
- How to Read a Frequency Response. What a speaker specification promises, and what it quietly leaves out.



