sE Electronics
SE Electronics V7 GOLD
Menge:
Optionen wählen
Menge:
Menge:
sE Electronics V7 Gold is a dynamic vocal microphone in a limited-edition gold finish, released to mark sE Electronics' 25th anniversary. Beneath the gold-finished housing and grille sits the same technical specification as the standard V7 — the DMC7 capsule with an aluminum voice coil, neodymium magnet, and supercardioid polar pattern. The visible differences versus the standard version are the finish, the gold-plated XLR connector, and the windscreen set: black (installed from factory) and yellow (spare in the box).
DMC7 supercardioid capsule and patented integrated shockmount
The V7 Gold's supercardioid pattern provides a narrower acceptance angle than a cardioid and more effective lateral rejection — higher gain-before-feedback without having to pull bass frequencies out of the monitor mix. The aluminum voice coil on a neodymium magnet delivers fast transient response and an open, transparent sound across 40 Hz–19 kHz, with a gentle presence lift in the upper midrange that allows vocals to cut through a dense mix without relying on EQ. The patented internal shockmount mechanically decouples the capsule from the housing — vibrations transmitted through the vocalist's grip don't reach the signal path, which means less mechanical noise in the monitors without needing to apply a highpass filter to compensate. The all-metal construction (zinc alloy chassis, dent-proof and corrosion-resistant spring steel mesh grille) and beveled grille edge prevent the microphone from rolling off an amp top or the stage floor when set down.Gold-plated XLR connector and included accessories
The gold-plated XLR connector reduces contact resistance and eliminates oxidation at the connector over years of touring use — a practical detail, not only an aesthetic one. Included in the box: mic clip, 5/8"-to-3/8" thread adapter, carrying pouch, and two internal windscreens (black and yellow). The V7 Gold is a standard wired microphone on a 3-pin XLR connector — no phantom power or batteries required.KEY FEATURES
- DMC7 dynamic capsule — aluminum voice coil, neodymium magnet
- Supercardioid polar pattern — higher gain-before-feedback, narrower pickup than cardioid
- Patented integrated shockmount — minimal handling noise during stage movement
- Switchable internal windscreen — black (installed) and yellow (spare) included in box
- Zinc alloy housing, spring steel mesh grille — no plastic components
- Beveled grille edge — microphone does not roll when set down on a flat surface
- Gold-plated XLR connector — reliable, loss-free signal connection for long-term use
- Limited edition gold finish celebrating sE Electronics' 25th anniversary
- Included: mic clip, 5/8"→3/8" thread adapter, carrying pouch, two internal windscreens
TECHNICAL SPECIFICATIONS
- Transducer type: dynamic (moving coil)
- Polar pattern: supercardioid
- Frequency response: 40 Hz – 19 kHz
- Sensitivity: 2.0 mV/Pa (-54 dBV)
- Output impedance: 300 Ω
- Connector: 3-pin XLR (male), gold-plated contacts
- Housing material: zinc alloy; grille: spring steel
- Diameter: 54 mm (2.12 in)
- Length: 184 mm (7.24 in)
- Weight: 305 g (10.8 oz)
