The 011 FET-M is a factory-matched pair of small-diaphragm condenser microphones built around a custom, hand-machined 19mm gold-sputtered capsule and a transformerless FET circuit. Both units are tested and paired for near-identical sensitivity and frequency response, making them ready for stereo techniques - XY, ORTF, spaced pair, or drum overheads - without hand-matching two individual mics.
Consistent stereo imaging without manual pair-matching
Building a stereo pair from two individually purchased mics usually means comparing frequency-response and sensitivity charts to avoid the image pulling left or right. The 011 FET-M removes that step - both capsules are matched at the factory, so an engineer sets the pair up on overheads, piano, or a string section and gets a symmetrical, coherent stereo image without trimming levels between channels at the mix stage.
Transient detail without losing warmth
Small, low-mass diaphragms track fast transients better than large capsules, but on many budget designs that comes at the cost of warmth and natural tone. The 011 FET-M's transformerless circuit keeps a fast response to a plucked string or a struck cymbal while holding a controlled low end and a smooth midrange, so the extra detail doesn't sound sterile. Included -10dB pads let the pair sit close to a snare or cymbals without risking overload, up to a maximum SPL of 130dB.
KEY FEATURES
- Factory-matched pair of small-diaphragm condenser microphones
- Custom hand-machined 19mm gold-sputtered capsule
- Transformerless FET circuit
- Cardioid pattern, with optional hypercardioid and omnidirectional capsules
- Included -10dB pads (x2)
- Compact, lightweight body for precise placement
- Black matte finish
- Includes wooden case and microphone clips
TECHNICAL SPECIFICATIONS
- Type: small-diaphragm FET condenser microphone (factory-matched pair)
- Capsule: 19mm, gold-sputtered, hand-machined
- Polar pattern: cardioid (optional hypercardioid, omnidirectional)
- Frequency range: 20Hz - 20kHz
- Maximum SPL: 130dB
- Self-noise: 16dB (A-weighted)
- Sensitivity: 19mV/Pa
- Output impedance: 150 Ohms
- Pad: -10dB, inline, x2 included
- Length: 91mm
- Body diameter: 19mm, capsule head diameter: 24mm
- Weight: 76g (per microphone)
- Included accessories: wooden case, microphone clips, -10dB pads





